SmartQuant Discussion
http://www.smartquant.com/forums/

How to load and run solution from command line
http://www.smartquant.com/forums/viewtopic.php?f=64&t=8947
Page 1 of 1

Author:  Dr. Anton Fokin [ Sat Mar 12, 2011 11:02 am ]
Post subject:  How to load and run solution from command line

OpenQuant.exe [solution] [/r]

Example

OpenQuant.exe "C:\Users\Anton\Documents\OpenQuant\Solutions\Bollinger Bands\Bollinger Bands.oqs"

use /r command line parameter to run solution on startup

OpenQuant.exe "C:\Users\Anton\Documents\OpenQuant\Solutions\Bollinger Bands\Bollinger Bands.oqs" /r

Author:  DrKoch [ Thu Nov 17, 2011 11:44 am ]
Post subject:  Re: How to load and run solution from command line

If OQ is in "Live" mode the /r switch seems to not start any data and execution providers.

Could you please make the /r switch to behave like the "Run" Button?

(But skip this "You are about to run startegy in Live Mode. Do you want to continue?" Message)

Page 1 of 1 All times are UTC + 3 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/